Print this page.

1st Power Up mexico-flag-button-36w.jpg quebec-flag_button-w36.jpg

The following routine is followed only the first time SawGear is used, or whenever the interface language, measuring system, saw side or working length must be changed.

The messages shown below SCROLL across the screen if longer than the LCD's 16 character width.

User steps

LCD screen displays

  1. Plug into AC power. Press [Soft Start].

languages1-400x30.jpg

languages2-400x30.jpg

  1. Press [1], [2] or [3] to select language.

units1-400x30.jpg

units2-400x30.jpg

  1. Press [4] or [6] to select measurement system.

saw-left-press1-400x30.jpg

  1. Press [7] if the saw is to the left of SawGear, or [9] if the saw is to the right.

press-Start-to-move-400x30.jpg

  1. Press [Start] to move.

 

SawGear moves to the end away from the saw until it reaches maximum position.

Then it moves to the end closest to the saw until it reaches minimum position.

SawGear quickly displays

enter-wL-400x30.jpg

and then the SawGear working length, +/- 0.5 inch. (96.253 is only an example.)

wL-400x30.jpg

If the working length that displays is NOT the working length of the machine you are using the power head on, it MUST be changed. Enter the correct working length.

  1. Press [Start] to confirm the SawGear working length.

SawGear backs out and stops at 6”. CUT a sample at this length and MEASURE it.

 

enter-length-of-cut1-400x30.jpg

enter-length-of-cut2-400x30.jpg

  1. Enter the length of the sample and press [Start].

SawGear is now ready to use!

Repeat a 1st Power Up

If you need to change the interface language, the measurement system, or the saw location, or if you are moving the SawGear power head to a different measuring bar, you must perform a 1st power up.

Stop-41.jpg

Unplug the machine and plug it in again while HOLDING DOWN the [STOP] key.

soft-start-41.jpg

While still HOLDING DOWN the [STOP] key, press the soft start key until the active screen displays, and continue at 1st Power Up, step 2.