Print this page.

Editing a List

SawGear lets you save dimensions you are working with by storing up to 9 lengths in each of 10 cut lists.
The following examples show how to enter dimensions into a list that has been used before and contains cuts.
To enter dimensions into a list that is empty, see Saving Dimensions with List.

The messages shown below SCROLL across the screen if longer than the LCD's 16 character width.

SawGear is in Foot mode for these examples.

User steps	LCD screen displays
Press [List].
Enter [5]. Or any number from 0 to 9.
The screen displays "List#" followed by the number you entered. SawGear will move to the first length when you press [Start], so be sure nothing is in the way. If this is NOT the list number you want, exit by pressing [STOP]. If the list number you entered is correct…
Press [Start].
SawGear moves immediately to the first saved length and displays its current position.
Enter the new cut length for line 1.
The dimension displays exactly as you entered it. In Foot mode, inches is assumed.
Press [Start]. SawGear moves immediately to the new length and displays its current position.
Press [Start] to advance to the next line in the cut list.
SawGear moves immediately to the next saved length and displays its current position.
Enter the new cut length for line 2.
The dimension displays exactly as you entered it. In Foot mode, inches is assumed.
Press [Start]. SawGear moves immediately to the new length and displays its current position.
At any point you can exit the list by pressing [STOP] and the edits will be saved.
Press [STOP] to exit a list.
If there are any cuts in lines AFTER the last line you edited, they will remain. If you want to END the list after your last edit, see Clear a Cut length.
See also: Using a Saved Cut List