SawGear Control

[Soft Start] switches off power to save energy.

[W] Molding Width Entry for cutting 45° miters.

[X] Left Stile Inside Length Entry for miters.

[Y] Header Inside Length Entry for miters.

[Z] Right Stile Inside Length Entry for miters.

[Ft] Feet Entry denotes numbers as Feet.

[In] Inches Entry denotes numbers as Inches.

[/] Slash is used to enter fractional numbers.

[<±>] Increment adds or subtracts from current position by a given amount.

[List] List stores dimensions for later use.

[-D-] Calibrate sets the distance from the saw blade.
Also used to set or kill sleep mode.

[STOP] Stop halts movement immediately.

[Start] Start accepts an entered dimension, and causes movement.

[Clr] Clear backs up and erases one digit at a time to correct a data entry error.

Also used to clear a cut length.

[.] Decimal is used to enter decimal numbers in both metric and inches.

[.] [.] [.] inserts a minus sign before a dimension, allowing entry of negative numbers.

[n] Number keys are used to enter dimensions.