Straight Cutting

SawGear has been set up on a chop saw or miter saw and has been homed and is now ready to run.

SawGear can be used in Foot Mode or in Metric Mode.

Basic Operation

Consists of two simple steps:

1. Enter a dimension and hit [Start].

2. When SawGear moves to position, make your cut(s).

How to Enter Dimensions

Depends on whether you work in feet, inches and fractions, feet and decimal inches, or millimeters.

Click on the link below that describes your measuring and dimension entry method:

Entering Feet, Inches and Fractions

Entering Feet and Decimal Inches

Entering Millimeters

Entering Non-Standard Fractions

Negative Numbers

Data Entry Errors

Entering Negative Numbers

"Too Big" Error   "Too Small" Error

Correcting Entry Errors